AS 2129 table D,Table E Flanges for pipes, valves and fittings

We specialize in manufacturing high-quality of  AS 2129  flanges according to Table D and Table E standard.

Carbon Steel:ST37,S235JR,ASTM A105,

Stainless Steel

• 304 / 304L (S30400/S30403) — for general corrosion resistance

• 316 / 316L (S31600/S31603) — for resistance to pitting, stress corrosion, and chloride attack

• ** duplex (S31803/S32205)** — for greater resistance in aggressive environments (depending on service)

Pipe Flange Table D AS2129

• To suit Schedule Pipe
• Manufactured to AS2129 Table D Standard (*)
• Forged to ASTM A182
• Flat Faced Slip On Flange (FFSO/SOFF)
• All sharp edges have been chamfered by 0.5 mm at 45°

Introduction

AS 2129 Table D Flanges are widely used in petrochemical, water, and industrial pipeline applications where lower pressure (up to 700 kPa or 100 psi) is sufficient.
Table D specifies dimensions, pressure ratings, materials, and technical delivery conditions for flanges used in pipeline assemblies.

Flange Type

AS 2129 Table D Flanges are typically available in:

✅ Plate Flanges
✅ Blind Flanges
✅ Threaded Flanges
✅ Bossed Flanges
✅ Lap Joint Flanges (with stub ends)
✅ Weld Neck Flanges (with raised face or flat face)

Flange Size Range

✅ Nominal Size (DN): 15 (1/2″) — 600 (24″)
✅ Flange Thickness: 12–20 mm (depending on size)
✅ Flange Facing: flat face (typically)
✅ Flange Drilling: to AS 2129 Table D standard

AS 2129 Table E Flanges

AS 2129 Table E Flanges are widely used in petrochemical, water, industrial pipeline, and power generation applications where moderate pressure (up to 1,400 kPa or 200 psi) is required.
Table E specifies dimensions, pressure ratings, materials, and technical delivery conditions for flanges used in pipeline assemblies.

Flange Type

AS 2129 Table E Flanges are typically available in:

✅ Plate Flanges
✅ Blind Flanges
✅ Threaded Flanges
✅ Bossed Flanges
✅ Lap Joint Flanges (with stub ends)
✅ Weld Neck Flanges (with raised face or flat face)

Flange Size Range

✅ Nominal Size (DN): 15 (1/2″) — 1200 (48″)
✅ Flange Thickness: 12–30 mm (depending on size)
✅ Flange Facing: flat face (typically)
✅ Flange Drilling: to AS 2129 Table E standard (with standard number of holes, P.C.D, and hole size)

AS2129 Flange table D Table E Dimension